15
English
Tab 6, 12
Tab 2, 8, 14 Tab 3, 9, 15 Tab 4, 10, 16 Tab 5, 11
Pairing a phone for use with multi-point
Before proceeding, be sure to disable Bluetooth on any phones
already paired to the headset.
1. Turn on both the headset and the phone.
2. Press and hold both the Volume + and Call buttons for
5 seconds to enable multi-point and make the headset
discoverable.
3. Complete the pairing procedure specific to this phone.
4. Turn the headset off and then on again to allow the headset to
connect to the two phones you want to use.
Be sure to enable Bluetooth on the two phones you want
connected.
Disabling the multi-point feature
If you are no longer using multi-point, it is wise to disable this
feature as follows:
1. Press and hold the Call and Volume – buttons for 10 seconds.
2. Turn the headset off and then on again. This eliminates all
pairing.
3. Re-pair the headset and mobile phone you still use. See
“Pairing your headset and mobile phone” on page 7.
Note: Some phones require you to eliminate the BT1 pairing in the
Bluetooth list before you can re-pair to that phone.
VincentOG.book Page 15 Thursday, October 21, 2010 4:28 PM
To Next Page
Loading...
Need help?
General
