Bose CineMAte 520 - System Maintenance and Resets; Factory Reset Procedure

English - 31
Factory reset the system
To troubleshoot problems, reset the System menu and ADAPTiQ
®
to the
factory settings.
1. Press
on the remote control.
2. Press
until 16 FACTORY RESET appears on the display.
3. Press 5.
The system resets.
4. Run the ADAPTiQ audio calibration
(see page 19).
Reset a source button on the remote control
If you are experiencing problems with a source button on the remote control, reset
the source button to the factory settings.
After performing this procedure, your source button is in CEC mode.
1. On the remote control, press and hold the appropriate source button until all
six source buttons glow, then release.
Only the appropriate source button glows.
2. On the number keypad, enter 0140.
Service connectors on the Acoustimass
®
module
The Service and Data connectors are for service use only. Do not insert any cables
into these connectors.
Care and Maintenance