Connecting
the
Acoustimass® module
to
the
media
center
Connect the Acoustimass module to the media center with the audio input cable (Figure
9).
) Note: Be sure that each connector
is
fully inserted into each jack.
1.
Plug the small black multi-pin connector (flat side facing
up)
into the SPEAKER ZONES
jack labeled "1"
on
the back of the media center.
2. Insert the telephone-style RJ-45 connector
on
the other end of the audio input cable into
the AUDIO INPUT jack
on
the Acoustimass module. When properly connected,
it
should
lock
in
place.
) Note: Refer
to
USetting
up a second listening zone" on
page
23
for information on connecting
a second zone.
Figure 9
Acoustimass connection to
media center
Audio input cable
Note: Press tab
to
release cable connector.
When
fully inserted into the jack, the connector
locks
in
place.
12
A CAUTION:
00
not place strain on the audio input cable, especially on the connection
to
the
Acoustimass module. Placing excessive strain on the cable may cause damage
to
the cable
connection
at
the Acoustimass module.
When
disconnecting the cable from the Acoustimass
module, be sure
to
press the tab on the connector.
To Next Page
Loading...
