Terminal tab
Red
(+)
wire
Match the correct cable
to
the corresponding speaker location. Front speaker cables
have blue connectors at one end, with L (left), R (right), or C (center) molded into the con-
nectors. The red collars on the
+ wire are labeled
LEFT,
RIGHT,
and CENTER. Surround
speaker cables have orange connectors at one end, with L (left) or R (right) molded into
the connectors. The red collars on the
+ wire are labeled
LEFT
and
RIGHT.
2.
Connect the wire end
of
one speaker cable
to
the terminals on the rear
of
the matching
speaker. Press the terminal tab on the back
of
the speaker and insert the marked wire
(+)
into the red terminal and the plain wire (-) into the black terminal. Release the tab
to
secure the wire. Repeat this step for each
of
the five speakers.
3.
Connect each cable
to
the corresponding jack
on
the Acoustimass® module (Figure
8).
Plug the blue connectors into the matching left front, center, and right front jacks. Plug
the orange connectors into the matching left surround and right surround jacks.
~
1.
Figure 7
Connecting speaker cables
to the cube speakers
Figure 8
Speaker connections to the
Acoustimass ·module
Left
Front speakers
Center Right
Surround speakers
Left Right
11
To Next Page
Loading...
