Connecting the system
to
power
Connect the
two
AC
power
(mains) cords
in
the following order:
1. Plug the small end
of
the Acoustimass® module
power
cord into the AC
power
jack
on the
connector
panel
of
the Acoustimass module (Figure 16). Plug the other end
of
the
power
cord into
an
AC (mains) outlet.
2.
Turn the Acoustimass module POWER switch
to
on
(I).
Figure
16
Power connection
of
the
Acoustimass module
Figure
17
Power connection
of
the
media center
Power supply
Connector panel
Power switch
DC
power jack
18
A CAUTION: For dual voltage units, make sure the voltage setting on the bottom
of
the media
center power supply matches the local power rating. Check with local electrical authorities
if
you are not sure about appropriate power rating.
Plug the small round connector
of
the media center
power
supply cable into the DC POWER
jack
on the
back
of
the media center (Figure 17). Insert the
power
supply line cord connector
into the
power
supply and plug the cord into
an
AC (mains) outlet.
To Next Page
Loading...
