Bose Lifestyle 3 - The Lifestyle remote control

BASIC SYSTEM CONNECTIONS
15
BASIC SYSTEM CONNECTIONS
English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsItaliano SvenskaDeutsch NederlandsFrançaisEspañol
Connecting the module to the media center
Use the audio input cable, which has a multi-pin connector at each end, to connect the
Acoustimass
®
module to the media center (Figure 11).
Figure 11
Audio input cable
with a flat-sided multi-pin
connector at each end
Note: Before you make this connection, you can plug the power adapter into the media center
first, while there are no other cables in the way. However, DO NOT plug the adapter into the AC
(mains) power outlet before all other connections are completed.
1. With the flat side of the multi-pin connector facing down, insert one connector end into
the Audio jack labeled on the back of the Acoustimass module (Figure 12).
Be sure the connector is inserted flat side down.
2. Use the other end of the cable flat side up. Insert it into the Speakers jack labeled Main
on the media center.
Make sure that each connector is fully inserted into the jack.
Figure 12
Acoustimass connection
to the media center
CAUTION: Do not put strain on the audio input cable where it connects to the module and
media center. Excessive strain, caused by pulling directly on the cable or by compressing it, can
cause damage.
Audio input cable
Media center
connection panel
Acoustimass module
connection panel
Flat side up
Flat side down
Power adapter
cord
Main
Speakers jack
Speakers Main
06.LSDVD_IG_Connections2.fm Page 15 Tuesday, May 30, 2006 6:12 PM