EasyManuals Logo

Bose SLEEPBUDS II User Manual

Bose SLEEPBUDS II
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
REGULATORY INFORMATION
4
|
ENG
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment o and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Bose Corporation could void the user’s authority to operate
this equipment.
This device complies with part 15 of the FCC Rules and with ISED Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This device complies with FCC and ISED Canada radiation exposure limits set forth for general population.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Right Bud; FCC ID: A94432893R
Left Bud; FCC ID: A94432893L
Right Bud; IC ID: 3232A-432893R
Left Bud; IC ID: 3232A-432893L
CAN ICES-3(B)/NMB-3(B)
For Europe:
Frequency bands of operation 2400 to 2483.5 MHz.
Maximum transmit power less than 20 dBm EIRP.
Maximum transmit power is below regulatory limits such that SAR testing is not necessary and exempt per
applicable regulations.
This symbol means the product must not be discarded as household waste, and should be delivered to an
appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources,
human health and the environment. For more information on disposal and recycling of this product, contact
your local municipality, disposal service, or the shop where you bought this product.
Management Regulation for Low-power Radio-frequency Devices
Article XII
According to “Management Regulation for Low-power Radio-frequency Devices” without permission granted by
the NCC, any company, enterprise, or user is not allowed to change frequency, enhance transmitting power or alter
original characteristic as well as performance to an approved low power radio-frequency devices.
Article XIV
The low power radio-frequency devices shall not influence aircraft security and interfere legal communications; If
found, the user shall cease operating immediately until no interference is achieved. The said legal communications
means radio communications operated in compliance with the Telecommunications Act.
The low power radio-frequency devices must be susceptible with the interference from legal communications or ISM
radio wave radiated devices.
DON’T attempt to remove the rechargeable nickel-metal hydride (NiHM) battery from this product. Contact your local
Bose retailer or other qualified professional for removal.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bose SLEEPBUDS II and is the answer not in the manual?

Bose SLEEPBUDS II Specifications

General IconGeneral
Cable length1 m
Headset typeBinaural
Product typeHeadphones
Product colorWhite
Wearing styleIn-ear
BluetoothYes
Wireless range9 m
3.5 mm connectorNo
Bluetooth version5.0
Connectivity technologyWireless
Microphone typeNot available
Battery typeBuilt-in battery
Battery technologyNickel-Metal Hydride (NiMH)
Battery recharge time6 h
Continuous audio playback time10 h
Battery recharge time (charging case)3 h
Cables includedUSB
Charging case typeWired
Accessories included in set3 sizes silicone eartips
MaterialAluminium, Plastic, Silicone
Weight and Dimensions IconWeight and Dimensions
Depth12.7 mm
Width27.9 mm
Height24.9 mm
Charging case dimensions (W x D x H)76.9 x 76.9 x 27.4 mm

Related product manuals