32
DISASSEMBLY PROCEDURES
4A. Metal Grille Removal
4A.1 Perform procedure 3 rst. The top cover
must be removed because pins in the top cover
t into the grommets on the metal grille securing
the top of the grille in place.
4A.2 On the bottom of the unit, remove the four
screws securing the grille as indicated in Figure
7.
4A.3 Turn the unit over. Grasp the grille by the
sides as indicated by the arrows in Figure 7A and
pull forward to release the grille edge from the
enclosure. Work the grille out of the cabinet using
care not to bend the grille.
Note: When installing the metal grille, make sure
the 5 rubber grommets are inserted in the grille
holes indicated in Figure 7A. When installing the
cover, ensure the 5 pins on the cover insert into
the grommets to ensure proper grille alignment.
4B. Cloth Grill Removal
4B.1 Perform procedure 3 rst. The top cover
has to be removed to properly grasp the grill to
remove it.
4B.2 Grasp a side edge of the grille and pull it
straight forward to release the grille clip from the
enclosure’s clip catch. Do this for both the other
side. See gure 7B and 8.
4B.3 After releasing the left and right side of the
grille, pull the grille forward working toward the
center releasing its posts from the grommets in
the enclosure. See Figure 9.
Grommets
Two rectangle grommets located front center
8 round grommets, 4 located on each side
Grille Side Clip Grille Side Clip catch
Figure 7. Metal Grille Screw Removal
Figure 7A. Metal Grille Removal
Figure 7B. Cloth Grille Removal
Figure 8. Cloth Grille Side Clip
Figure 9. Cloth Grille Enclosure Grommets
Location
To Next Page
Loading...
