33
DISASSEMBLY PROCEDURES
5. Driver Removal
5.1 Perform procedures 4 rst.
5.2 Remove the four screws securing the driv-
er. Pull out the driver and disconnect the driver
wire harness from the driver. See Figure 10.
Note: To remove the center drive, perform
procedure 6 rst.
6. IR PCB Removal
6.1 Perform procedures 4 rst.
6.2 Disconnect the at ex cable from the IR
PCB.
6.3 Remove 2 screws securing the IR board.
as indicated in Figure 11.
Two Side Drivers
Three Side Drivers
Figure 10. Driver Removal
Figure 11. IP PCB Removal
To Next Page
Loading...
