27
DISASSEMBLY PROCEDURE
Figure 7. Main PCB removal
Figure 8. Main PCB removal
Figure 9. Grille Removal
Figure 10. Grille Removal
Main PCB Removal (continued)
2.5 Once the PCB is out from the enclosure,
you will notice the transducer harness is at-
tached to the PCB. Figure 7.
2.6 Detach the transducer cable from the main
PCB. Figure 8.
Note: Use a spudger or screw driver to re-
lease the locking tab from the transducer
cable.
3. Metal Grille Removal
3.1 On the bottom of the unit, remove the
two screws securing the grille as indicated in
Figure 9.
3.2 Then using a spudger, push the grille at
the edge to move the metal grille forward from
enclosure. Figure 10. Repeat this process for
both side of the grille. This will create some
space for your fi ngers later.
3.3 Turn the unit over. Grasp the grille by the
sides and pull forward to release the grille
edge from the enclosure.
To Next Page
Loading...
