English - 11
Power On/Off Controls
Powering on the system
Press on the remote or the console.
The system status indicator on the console changes from blinking to solid green.
The system is now ready to use.
To power your system and open the SOURCE menu
Press SOURCE on the remote or the control console.
To power your system and open the UNIFY
®
menu
Press Setup on the control console.
Note: The system operates in a power saving mode when it is off to keep energy
consumption low, so it may take several seconds to start.
Powering on your TV
Press .
Note: If you did not program your remote during the initial setup using UNIFY
®
, use
the remote that came with your TV.
Shutting down the system
Press on the remote or the console.
The system shuts down after a few seconds.
Note: If you decide to access the power controls for connected devices, automatic
shutdown is stopped and you must complete the shutdown using the
onscreen controls.
To Next Page
Loading...
