18
Using the alarms
Function
To stop the alarm - Press ON/OFF. The indicators remain lit.
Or, if you do not press ON/OFF, the tone alarm shuts off in 30 min-
utes, the radio alarm shuts off in 60 minutes.
The alarm automatically resets to repeat daily.
To pause the alarm for 10 minutes - Press SLEEP⁄SNOOZE or
SLEEP to have the radio or tone alarm repeat in 10 minutes. When
the alarm is in both radio and tone mode, press SLEEP⁄SNOOZE
or SLEEP to pause the tone for 10 minutes and turn on the radio. Press
SLEEP⁄SNOOZE or SLEEP again to silence the radio - the tone repeats in
10 minutes.
You can repeat the pause cycle as many times as you want. If you do not
press any button while the tone is sounding, it shuts off in 30 minutes.
To set the volume of the radio alarm - The radio alarm turns on
and gradually increases to the last volume setting used. You can select a
volume setting with the radio on or off.
To set the volume of the tone alarm - The tone alarm turns on
and gradually increases to the last tone setting used. You can set a
louder or softer tone by pressing VOLUME up or down while the tone is
sounding.
To use the alarm during a power failure - Press ON/OFF to
silence. The backup battery runs the alarm for approximately three days
without AC power. To conserve power, only the tone alarm sounds even
if radio alarm is selected. Normal operation resumes when power is
restored. Replace the 9V battery after an extended power failure.
WAVE RADIO
ALARM MODE
ALARM
SET
CLOCK
SET
VOLUME
PRESET STATIONS
123
456
TUNING
SLEEP/SNOOZE
AUX AM/FM ON/OFF
Control panel
TIME
ALARM
SLEEP
TUNING
STA.
VOLUME
MUTE
AUX
AM
FM
ON/OFF
WAVE RADIO REMOTE CONTROL
1
23
4
5
6
PRESET STATIONS
Remote control
ON/OFF
ON/OFF
Operating Your Wave
®
Radio
SLEEP/SNOOZE
SLEEP
VOLUME
ON/OFF
ON/OFF
VOLUME
VOLUME
To Next Page
Loading...
Need help?
General
