Need help?Do you have a question about the Boss Audio Systems AR2000M and is the answer not in the manual?
General| Amplifier Class | A/B |
|---|---|
| THD @ RMS Output | 0.01% |
| Minimum Impedance Unbridged | 2 Ohms |
| Subsonic Filter | 15 Hz to 40 Hz |
| Bass Boost Frequency | 45 Hz |
| RCA Inputs | Yes |
| Speaker Level Inputs | Yes |
| RMS Power @ 2 Ohms | 1000W |
| Max Power @ 2 Ohms | 2000 Watts |
| Low Pass Crossover | 50 Hz to 250 Hz |
| Bass Boost | 0dB - 12dB |
| Input Sensitivity | 0.2V to 6V |
Lists the 2-channel MOSFET power amplifiers covered in the manual.
Lists the 4-channel MOSFET power amplifiers covered in the manual.
Lists the monoblock MOSFET power amplifiers covered in the manual.
Provides an overview of the ARMOR MOSFET amplifier series.
Lists the items included in the amplifier package.
Offers solutions for common amplifier operational problems.
Highlights key features of the ARMOR amplifier series.
Explains the implications and benefits of operating at a 2 Ohm load.
Illustrates wiring for monoblock amplifiers in mono mode.
Provides safety advice and installation steps for the amplifier.
Shows wiring for 4-channel amps in Tri-Mode for speakers and subwoofer.
Demonstrates wiring for 4-channel amps in 4-channel and bridged configurations.
Guides on the step-by-step process of connecting the amplifier.
Explains low-level RCA and high-level speaker input connections.
Shows 2-channel amp wiring for stereo and bridged modes.
Advises on the correct use of the input level control to prevent distortion.
To Next Page