What to do if my Boss Audio Systems ELITE BV755B Receiver unit will not power on?
If your Boss Audio Systems Receiver won't power on, it could be due to a blown fuse. Check the radio fuse and the car battery fuse; if either is blown, install a new fuse with the correct rating. Also, an illegal operation may have occurred, in which case you should press the RESET button.
Why is there no audio output from my Boss Audio Systems ELITE BV755B Receiver?
If you're getting no audio output from your Boss Audio Systems Receiver, there are a couple of things to check: * First, verify the audio output connections are properly wired and correct any issues. * Second, make sure the volume isn't set to 0. If it is, simply turn up the volume.
Why is the image flashing or showing interference on the screen of my Boss Audio Systems ELITE BV755B Receiver?
A flashing image or interference on the screen of your Boss Audio Systems Receiver typically indicates improper video signal connections. Check the wiring and correct any issues.
What to do if the screen touch is insensitive on my Boss Audio Systems ELITE BV755B Receiver?
If the touchscreen on your Boss Audio Systems Receiver is insensitive, it might be uncalibrated. Go to the setup menu and set the calibration.
Why is the sound quality poor or distorted on my Boss Audio Systems Receiver?
Poor sound quality or distortion from your Boss Audio Systems Receiver can be caused by a couple of issues: * The speaker power rating may not be compatible with the unit. Connect proper speakers. * There may be a speaker short circuit. Check the wiring.
What to do if my Boss Audio Systems Receiver shows 'No Disc/Bad Disc'?
If your Boss Audio Systems Receiver displays 'No Disc/Bad Disc', the disc may be dirty. Clean the disc. Alternatively, the disc may be upside down. Insert the disc the right way.
Why is the image improper, or the height/width of the radio display is incorrect on my Boss Audio Systems ELITE BV755B Receiver?
If the image is improper, or the height/width of the radio display is incorrect on your Boss Audio Systems Receiver, the aspect ratio setup may be wrong. Use the correct aspect ratio setting.
What to do if I am experiencing loss of noise during play, and the Boss Audio Systems ELITE BV755B Receiver stops then?
If you experience loss of noise during play and then the Boss Audio Systems Receiver stops, it could be due to: * A scratched or warped disc. Use a new one in good condition. * A dirty or wet disc. Clean the disc.
How to improve weak station searching on my Boss Audio Systems ELITE BV755B Receiver?
If you're experiencing weak station searching with your Boss Audio Systems Receiver, there are a couple of potential causes: * The auto antenna may not be properly connected. Connect the auto antenna properly. * The LOCAL function may be activated. Turn the LOCAL function OFF.
What to do if my Boss Audio Systems Receiver displays 'Unknown Disc'?
If your Boss Audio Systems Receiver displays 'Unknown Disc', it means the disc type is unsupported. Check the disc and change it.
General| Brand | Boss Audio Systems |
|---|---|
| Model | ELITE BV755B |
| Category | Receiver |
| Language | English |
Important statements regarding safe operation and viewing of the device.
Configure general settings like wallpaper, ACC power, system tone, language, and parental lock.
Configure camera trigger, rear camera power, and front camera power settings.
Set the clock mode (12/24 hr), hour, minute, and AM/PM settings.
Adjust internal amplifier, startup volume, tuner, disc, USB, SD, phone, streaming, AUX IN, and AV input levels.
Adjust equalizer, balance, fade, subwoofer, and preset gain levels.
Configure tuner region, auto preset, local/distance, RBDS, and stereo/mono settings.
Control illumination detection, screen brightness, and gamma brightness.
Access touch calibration, view version, reset to factory, or configure boot-up warning.
Configure Radio Data System features like Clock Time, Traffic Announcement, and Auto Frequency.
Access Bluetooth settings, dialing keypad, phonebook, call history, and pairing.
Dial phone numbers using the keypad or directly call contacts.
Manage active calls: show contact, mute/unmute mic, and hang up.
View and search contacts, sync phonebook, and manage call history.
Control music playback: previous/next song, play/pause, and access EQ settings.
Manage paired devices, disconnect, or forget existing connections.
View front camera feed, toggle display with rear camera.
View rear camera feed when reversing, returns to last source.
Connect external audio devices via 3.5mm jack.
Connect external video and audio devices via RCA jacks.
Steps and requirements for obtaining warranty service and repairs.
To Next Page