5mm Hex wrench ………………………………………………………………………………………1 PC
6mm Hex wrench …………………………………………………………………………………….. 1 PC
Features
Your new Phantom800 speakers feature the following:
3.5mm audio input
Adjustable speaker clamps
Weatherproof volume control
Weatherproof speakers
Bluetooth audio streaming
Built-in class D amplifier
Installation/Mounting
1. Adjust the direction of the speaker and screw the bracket to the bottom of the speaker.
2. Select the rubber inserts that fit your mounting bar and place them into the brackets.
3. Find a safe, ideal mounting location and fit the clamps over the chosen bars.
4. Fasten the mounting screws after you review the safety of the mounting location.
Reminder
The components and wiring should not be installed around any moving parts, keep away from ignition parts, fuel
lines, or any hot
exhaust components.
Speakers should not be installed where they might inhibit safety features on the vehicle ( i.e. lights, horns, brake
levers, etc.).
Power Supply Connection
Option A
Connected to Battery through a 12 VDC SPDT Relay (Single Pole Double Throw) NOT INCLUDED, SOLD
SEPARATELY
Option B
To Next Page