c) ELECTRIC SAFETY
The pump cable plug must match the socket. Never modify the plug in any way. Do not use any
adapter plugs. Unmodified plugs and matching sockets will reduce risk of electric shock.
Avoid body contact with earthed or grounded surfaces.
Do not abuse the electrical cord. Never use the cord for carrying, pulling or unplugging the pump.
Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase
the risk of electric shock.
When operating a pump outdoors, use an extension cord suitable for outdoor use.
The pump is equipped with a socket compatible with it. The power source of your country must be in
keeping with international regulations.
d) PERSONAL SAFETY
Risk of injury due to hot water. If the pump runs for an extended period when the outlet is closed,
the water in the pump can become heated so that hot water can emerge from the outlet and cause
injuries.
Stay alert, watch what you are doing and use common sense when operating a pump.
Maintain your pump. If the pump is damaged, ensure repair by a specialist before further use.
Follow these instructions to use the pump, its accessories, connectors, etc… properly. The pump
must be used only for its prescribed purpose. Any use other than those mentioned in this Manual will
be considered a case of misuse.
SYMBOL
The pump must be disposed of in accordance with local environmental regulations.
Read the instructions before use
To be checked before you start
BOSS™ 650 and BOSS
TM
950 Sump Pumps have been designed to suck clear water only.
Pumps have been designed to suck clear water or dirty water with particles (max particle sizes apply)
The pump must be installed on a flat and solid surface wherever possible.
2. GETTING STARTED
1. Connect a discharge pipe with a diameter at least equal to the diameter of the pump outlet
2. Immerse the pump in the liquid to be sucked, by making an angle of 45 degrees (to reduce the
amount of air trapped in the pump body). If the pump rests on the bottom, make sure it is on a flat and
stable surface.
3. Make sure that all persons are clear of the liquid to be pumped
4. Plug the pump to the mains
Version 1.0
BOSS™, ASHCROFT WAY, CROSS POINT BUSINESS PARK, COVENTRY, GB, CV2 2TU Created on: 04 July 2023
BOSS™ Technical Team - Tel:03330 341920 Email: BOSStechnicalteam@bssgroup.com Last updated: 04 July 2023
To Next Page
Loading...