3.WORKING PRINCIPLES & TECHNICAL SPECIFICATIONS
Version with float switch
The pump has a loose float which
start and stop the pump
automatically, depending on the
water level
Version with float switch
The pump has a loose float which start and
stop the pump automatically, depending on
the water level
4. ACCESSORIES
- Hose adapter :1 pc
5. USE AND DESTINATION OF THE PUMP
Your pump is designed to remove or transfer clean water
Your pump must not be used in following situations:
- Water temperature to be sucked greater than 35°C
- Continuous run
- Drinking water supply or washing machines for dishes supply
- Corrosive, easily combustible, aggressive or explosive liquids (such as gasoline, petroleum or
thinners), saltwater, oils and greases must not be pumped
- Permanent submersion under 3 metres or more water
6. CARE & MAINTENANCE
- In case of temporary installation, the pump must be cleaned up with clear water after use.
- In case of permanent installation, it is necessary to check every 3 months that the start mechanism is
working properly (float switch)
- Regularly remove dirt that may accumulate in the sump.
- Do not expose to frost.
- Avoid dry running.
- Do not abuse the electrical cord. Never use the cord for carrying, pulling or unplugging the pump.
- Clean the pump regularly if aspirated liquid causes sediments.
- Avoid shocks, do not let the pump fall.
Version 1.0
BOSS™, ASHCROFT WAY, CROSS POINT BUSINESS PARK, COVENTRY, GB, CV2 2TU Created on: 04 July 2023
BOSS™ Technical Team - Tel:03330 341920 Email: BOSStechnicalteam@bssgroup.com Last updated: 04 July 2023
To Next Page
Loading...