How to fix Boss Voice Recorder power won't turn on?
To troubleshoot a Boss Voice Recorder that won't turn on, ensure the power switch is set to “USB” if using USB bus power, or to “ON” if using the AC adapter or batteries. Also, if you're using a notebook computer running on battery, connect an AC adapter to your computer. Check your computer's settings and if using a USB hub, ensure it is self-powered.
Why no sound from my Boss BR-800?
If you're not getting any sound from your Boss Voice Recorder, first check that the BR-800 and any connected equipment are powered on. Ensure the PHONES LEVEL isn't set to 0, the audio cables are correctly connected and not broken, and the volume on any connected amp or mixer isn't turned down. Also, check that the [MASTER] fader isn't lowered, a supported SD card is inserted, you're not trying to play back a phrase shorter than 1.0 seconds, and DIR MONITOR isn't turned 'OFF'.
How to eliminate noise in Boss Voice Recorder?
If your Boss Voice Recorder recorded sound contains noise or distortion, adjust the input sensitivity so that the PEAK indicator briefly lights when the loudest passages occur. If the noise or distortion occurs after mastering, the track output levels may be too high. If needed, pass the signal through a commercially available microphone preamp before recording.
What to do if can't record with Boss BR-800?
If you can't record with your Boss Voice Recorder, check if the song is protected. Ensure an SD card is inserted and has sufficient free space, and that it is not locked. Also, verify that you are not using the Phrase Trainer, scrub playback, or control surface mode.
How to stop oscillation in Boss Voice Recorder?
If you're experiencing oscillation with your Boss Voice Recorder, you can stop playback in your software, turn off the Soft Thru function, turn off the audio input of your software, or change INPUT SELECT to a setting other than “USB.”
How to turn off reverb in Boss Voice Recorder?
To turn off the reverb on your Boss Voice Recorder, check the reverb send level amounts for the loop effect. Set each track’s send level amount to '0' to disable the reverb effect.
Why can't hear input source on Boss Voice Recorder?
If you can't hear the input source on your Boss Voice Recorder, ensure that INPUT SELECT is set correctly. Also, check if you have adjusted the INPUT SENS knob appropriately and that the [REC LEVEL] knob is not minimized.
Why is the volume low on my Boss BR-800?
If you're getting insufficient volume from a device connected to the GUITAR/BASS jack or LINE IN jack on your Boss Voice Recorder, use a connection cable that does not contain a resistor. Also, make sure the volume of your external device is adjusted correctly.
Why no sound from a track on Boss Voice Recorder?
If there is no sound from a specific track on your Boss Voice Recorder, check if the track’s volume level is lowered, the wrong V-track is selected, or the track is muted.
Why Boss BR-800 Voice Recorder can’t play WAV file?
If your Boss Voice Recorder can’t play back a WAV file, it could be due to attempting to play back a WAV file in an unsupported format.
General| Simultaneous Playback Tracks | 8 |
|---|---|
| Sampling Frequency | 44.1 kHz |
| A/D Conversion | 24-bit |
| D/A Conversion | 24-bit |
| USB Interface | USB 2.0 |
| Data Format | WAV, MP3 |
| Internal Microphones | Stereo |
| Display | Backlit LCD |
| Power Supply | AC adapter or AA batteries |
| Storage Media | SD/SDHC card |
| Effects | Yes (BOSS COSM effects) |
To Next Page
