Boss BV9974B - Page 12

After the scanning is finished, broadcasting will resume on the M1.(lt can store 3x6
stations for FM and 2x6 stations for AM)
2) When pressing the APS button briefly, the radio will scan each preset station for 5
seconds in FM or AM band from M1.
After finishing a circle of scanning, it will resume broadcasting on the M1.
NOTE: In FM band, FM1 ,FM2,FM3 is checked one at a time; In AM band, AM1, AM2 is
checked one at a time.
5. PRESET STATION [ 1-6] BUTTONS
In
RADIO mode:
1) To memorize the current frequency on the current band, long press any of the number
buttons (1-6) on remote control or on the front panel.
2) To recall the preset memory on the current band, briefly press one of the preset buttons
[1-6] on remote control or on the front panel.
6.
STEREO/MONO BUTTON
Press the ST button on the remote control to select the STEREO or MONO sound
mode for FM band.
7. LOC
BUTTON
1) In RADIO mode, when the signal of the distance radio station is very weak and the
receiving effect is bad during tuning. If there is the word LOC on the monitor, press this
button to turn off the LOC function, then tune again for the distance radio station;
2) In RADIO mode, when the signal of the local radio stations are too strong and the inter-
ference doesn t allow the tuner to lock on stations, press this button to turn on the LOC
function to display the word LOC on the monitor, then tune again for the local radio stations.
8. PTY (PROGRAM TYPE) BUTTON
Press the PTY button shortly to select one of the following mode:
PTY MUSIC group- - PTY SPEECH group -- OFF
When PTY group is on, press the VOL + or VOL- button on the remote control or rotate
the VOL knob on the front panel to select one of PTY programs as follows:
<-->NEWS<-->AFFAIRS<-->INFO<-->SPORT<-->EDUCATE<-->DRAMA<-->CULTURE
<-->SCIENCE<--> VARIED<-->WEATHER<--> FINANCE<-->CHILDREN<-->SOCIAL
<-->RELIGION<-->PHONE IN<-->TRAVEL<-->LEISURE<-->DOCUMENT< -->PTY
NONE<-->POP M< -->ROCK M<-->EASY M<-->L1GHT M<--> CLASSICS<-->OTHER M
<-->JAZZ<-->COUNTRY<-->NATION M<-->OLDIES<-->FOLK M<-->
When PTY group is on, pressing the 6 number buttons also can select one of PTY
programs as above.
After selecting one of the PTY programs, it will display SEEK PTY and automatically
search for the station of the PTY program. If the station of the PTY program does not exist,
it will display PTY NONE and then return back to the normal station.
9. AF
[ALTERNATIVE FREQUENCIES] BUTTON
When AF button is pressed briefly, the AF switching mode is selected and the status of the
AF switching mode is displayed by AF segment on the display.
Segment off: AF switching mode off.
Segment on: AF switching mode on, and has RDS information.
Segment flashing: AF switching mode on, but RDS information is not received yet.