Boss CL-50 - Page 7

@ Gate: Threshold Knob
Adjusts
the
Threshold
Level
for
the
Gate.
Clockwise
rotation
(),
increases
the
Threshoid
Level,
When
set
to
"OFF,"
the
Gate
is
disabled,
@ Gate: Decay Knob
Provides adjustment of the amount of time over which
sound will decay after the input signals have dropped
below the Threshold Level. Clockwise rotation
increases the Decay Time.
® Comp Indicator
Lights when the Comp/Gate is “In”,
whether it is switched “In” or “Out”,
Used to confirm
® Comp/Gate Switch
Used to switch the Comp/Gate “In” or “Out”, When
the switch is In (am), the input signal is routed
through the Compressor/Limiter/Gate before being
output, When the switch is Out (IML) the signal is out-
put directly (bypassed) .
@® Power Indicator
Lights when the Power Switch is turned on, indicating
that the unit is ready for operation.
® Power Switch
Turns power on or off. When “On” (=), the Power
Indicator lights indicating that the unit is ready for
operation,
+ Make sure you turn the volume on your amplifier to
“0” before turning the power switch on.
+ No signal will be output from the unit for a few sec-
onds after power is turned on since a muting circuit
is in effect at that time.