Boss PH-1 - Page 4

CAUTIONS
FOR
REPLACING
AND
HANDLING
BATTERY
PEDAL (COVER)
=
REPLACING BATTERY
USE ONE 9-VOLT BATTERY.
@ Loosen the screw of pedal to open it
and take out battery from its housing.
@
Replace
the
battery
by
a
fresh
one
and
put
it
into
position.
@
Set
coil
spring
onto
the
projection
on
the
rear
of
the
pedal
and
shut
the
cover
(pedal).
Finally,
insert
the
screw
into
the
pedal
guide
and
tight-
en
it.
At this time, be careful not to catch
the battery strap in the cover or coil
spring.
CAUTIONS
When you don’t use far a long period,
remove the battery to prevent current
leakage and leaking out of sticky sub-
stance.
ef battery voltage drops, effect becomes
inferior or no sound is produced. To
prevent that, replace the battery a little
earlier.
AC ADAPTOR (OPTION)
When
you
operate
PH-1
from
AC
line,
use
AC
adaptor
for
PH-1.
r se
BOSS ACA-120
FOR 117V AC
BOSS ACA.240
FOR 240V AC
@ Be sure to keep the battery snapped by
connector into the housing, when using
AC adaptor, too.
* Even if AC Adaptor cord comes out
during performance, operations imme-
diately changes to battery, causing no
trouble in continued performance.
ePower is switched on while a plug is
put into input jack. When you do not
use, keep the plug off the jack.
BOSS ACA-220
FOR 220V AC