Boss RC-3 Loop Station User Manual

24
Specications
Nominal Input Level
INPUT: -20 dBu
AUX IN: -10 dBu
Input Impedance
INPUT: 1 M ohm
AUX IN: 22 k ohms
Nominal Output Level -20 dBu
Output Impedance 1 k ohm
Recommended Load
Impedance
10 k ohms or larger
Recording/Playback
Maximum recording time: Approx. 3 hours
Maximum number of stored phrases: 99 phrases
Data format: WAV (44.1 kHz, 16-bit linear,
stereo)
USB Interface USB 2.0/1.1 mass storage device class
Power Supply
DC 9 V:
Alkaline battery (9 V, 6LR61),
AC Adaptor (PSA-series: sold separately)
* Rechargeable Ni-MH batteries cannot
be used.
Current Draw
Maximum 70 mA (DC 9 V)
Alkaline battery (9 V, 6LR61)
:
Approx. 3 hours
* These gures will vary depending on
the actual conditions of use.
Dimensions
73 (W) x 129 (D) x 59 (H) mm
2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inches
Weight 450 g/1 lb (including battery)
Accessories
Owner’s Manual,
Leaet (“USING THE UNIT SAFELY,”
“IMPORTANT NOTES,” and “Information”),
Alkaline battery (9 V, 6LR61): already
installed in unit
* The battery that was supplied
with the unit is for temporary use,
intended primarily for testing
the unit’s operation. We suggest
replacing this with an alkaline dry
cell.
Options
(sold separately)
AC Adaptor (PSA series)
Foot Switch: FS-5U, FS-6
* 0 dBu= 0.775 Vrms
* In the interest of product improvement, the specications
and/or appearance of this unit are subject to change without
prior notice.
BOSS RC-3: Loop Station

Boss RC-3 Loop Station Specifications

General

Sampling Frequency	44.1 kHz
Number of Tracks	1
Type	Looper
Recording Time	3 hours (stereo)
Inputs	AUX in
Outputs	1/4" output
USB	Yes (2.0)
Power Source	9V DC adapter
Weight	450 g
Memory	3 hours (Internal)
Loop Time (stereo)	3 hours