6
1. Carefully strip about 3/8˝ (10mm) of insulation and
twist the wire tip.
2. Loosen the knob and insert the wire.
3. Tighten the knob to fix the wire in place.
CONNECTING SPEAKERS
General connection using bare wire
1. Loosen the knob and insert the spade connector.
2. Tighten the knob to fix the wire in place.
Connection using spade connectors
1. Tighten the knob. 2. Insert the plug fully into the hole on the knob.
Connection using banana plugs
To Next Page
Loading...
