What to do if Bovie Medical Equipment shows error F2?
If the Bovie Medical Equipment displays error code F2, release either the cut or coag button on the handpiece, or the cut or coag pedal on the footswitch.
What to do if Bovie Aaron 1250 shows error E7?
If the Bovie Medical Equipment displays error code E7: 1. Turn the unit off. 2. Allow the unit to cool for 20 minutes. 3. Turn the unit on. 4. If the error code reappears, record the number and contact Bovie® customer service.
What to do if Bovie Aaron 1250 shows error E6?
If the Bovie Medical Equipment displays error code E6: 1. Turn the unit off. 2. Verify that the unit is connected to the line voltage. 3. If the error code reappears, record the number and contact Bovie® customer service.
What to do if Bovie Medical Equipment shows error F1?
If the Bovie Medical Equipment displays error code F1: 1. Turn off, then turn on the generator. Do not press buttons or activate accessory devices during the self-test. 2. If the error code reappears, disconnect all accessories. Turn off, then turn on the generator again. 3. If the problem persists, replace the handpiece or footswitch and repeat the restart. 4. If the error code reappears, record the number and call Bovie® customer service.
What to do if Bovie Aaron 1250 shows error E4?
If the Bovie Medical Equipment displays error code E4: 1. Turn the unit off. 2. Turn the unit on. 3. If the error code reappears, record the number and contact Bovie® customer service.
Why won't the footswitch activate my Bovie Medical Equipment?
The Bovie Medical Equipment will not allow the footswitch to activate the unit if Bipolar footcontrol is selected, but the Bipolar Mode is not selected.
Provides critical safety warnings, hazards, and lists any conditions where use is not advised.
Covers initial inspection, installation, and functional verification of the generator and its modes.
Covers pre-operation safety, setting up the unit, and preparing for monopolar or bipolar surgery.
Details critical safety measures during activation and step-by-step guides for unit activation.
Lists common error codes, their descriptions, and recommended actions for resolving issues.
General| Type | Electrosurgical Generator |
|---|---|
| Output Power | 120 watts |
| Line Voltage | 100-240 VAC |
| Modes | Cut, Coagulation, Bipolar |
| Cut Mode | Blend |
| Coagulation Mode | Desiccation, Fulguration |
To Next Page
