What to do if the Bovie Medical Equipment shows a line voltage error?
If you see a line voltage error on your Bovie Medical Equipment, follow these steps: First, turn the unit off. Second, check that the unit is connected to the correct line voltage. Finally, if the error code still appears, record the error number and contact Bovie Medical Corporation customer service.
What to do if the Bovie Medical Equipment overheats?
If your Bovie Medical Equipment indicates that the internal temperature has exceeded its limit, here's what to do: First, turn the unit off. Second, let the unit cool down for 20 minutes. Third, turn the unit back on. If the error code reappears after this, record the number and then contact Bovie Medical Corporation customer service.
What to do if handswitch or footswitch pedal is stuck on Bovie Medical Equipment?
If the handswitch or monopolar footswitch pedal on your Bovie Medical Equipment seems to be stuck, try the following: 1. Turn off, then turn on the generator, ensuring no buttons are pressed or accessory devices activated during the self-test. 2. If the error code returns, disconnect all accessories, then turn the generator off and on again. 3. If the problem continues, replace the handpiece or footswitch and repeat the restart process. 4. Should the error code still reappear, record the number and contact Bovie Medical Corporation customer service.
Crucial warnings for the safe and effective use of electrosurgical equipment.
Details significant hazards related to fire, explosion, and electrical shock during operation.
Provides essential cautions and notices for patient safety and proper equipment handling.
Explains controls for Cut, Blend, and Coagulation modes, including power settings.
Details controls for Fulguration, Bipolar modes, and user-defined presets on the front panel.
Crucial safety measures and step-by-step guide for setting up the generator for operation.
Precautions to prevent hazards during unit activation and operation.
Lists common error codes, their descriptions, and recommended actions for resolving issues.
General| Type | Electrosurgical Generator |
|---|---|
| Frequency | 500 kHz |
| Line Frequency | 50/60 Hz |
| Modes | Cut, Blend, Coagulation |
| Line Voltage | 100-240 VAC |
| Display | LED |
To Next Page
