ACTIVATING THE UNIT
Monopolar Activation
1. If the unit is not already set up, follow the set up procedure to prepare the unit for operation.
2. Remove the handpiece from the holder. Place the handpiece in the desired position.
3. To activate the unit, depress the activation button on the handpiece (see figure 4-1, letter L) or depress the pedal on the
footswitch. While the unit is activated, the appropriate audible tone is sounded and one of the activation LEDs will
illuminate
(see figure 4-1, letter N).
4. When the procedure is completed, turn the unit off.
5. Return the handpiece to the holder on the right side of the unit and remove the electrode. The electrode should be
disposed of after each procedure. If contamination has occurred to the handpiece, the handpiece should be
sterilized.
NOTICE:
When sterilizing the handpiece follow the manufacturer’s sterilization instructions that accompany the handpiece.
Bipolar Activation
1. If the unit is not already set up, follow the set up procedure to prepare the unit for operation.
2. Place the forceps in the desired position.
3. To activate the unit depress the footswitch pedal. While the unit is activated, an audible tone is sounded and the
blue activation LED will illuminate
(see figure 4-1, letter N).
4. When the procedure is completed, turn the unit off.
5. Remove the forceps from the bipolar cord and sterilize.
NOTICE:
When sterilizing the forceps follow the manufactures sterilization instructions that accompany the forceps.
4-7
User’s Guide • Aaron 950
™
To Next Page
Loading...
