Need help?Do you have a question about the Bowers & Wilkins CM10 S2 and is the answer not in the manual?
Instructions for mounting speakers on the floor using spikes or rubber feet and fitting the plinth.
Guide on screwing spikes into the plinth and adjusting them for a stable, level speaker.
Ensures all connections are made with audio equipment switched off and proper polarity.
Explains terminal links for conventional connection and removal for bi-wiring or bi-amplification.
How moving speakers and using foam plugs affects bass volume and depth.
Instructions on using two-piece foam bungs (outer or complete) for fine-tuning low-frequency performance.
General| Product color | White |
|---|---|
| Housing material | - |
| Recommended usage | Universal |
| Suitable for outdoor use | No |
| Tweeter | Yes |
| Speaker type | 3-way |
| Woofer diameter | 165 mm |
| Tweeter diameter | 25 mm |
| Number of drivers | 5 |
| Speaker placement | Floor |
| Audio output channels | 1.0 channels |
| Number of woofer drivers | 3 |
| Driver diaphragm material | Kevlar |
| Mid-range driver diameter | 150 mm |
| Number of tweeter drivers | 1 |
| Woofer diameter (imperial) | 6.5 \ |
| Tweeter diameter (imperial) | 1 \ |
| Mid-range driver diameter (imperial) | 6 \ |
| Recommended amplifier power (max) | 300 W |
| Recommended amplifier power (min) | 30 W |
| Impedance | 8 Ω |
| Sensitivity | 90 dB |
| Frequency range | 45 - 28000 Hz |
| RMS rated power | - W |
| Crossover frequency | 4000 Hz |
| Total Harmonic Distortion (THD) | 1 % |
| Connectivity technology | Wired |
Weight and Dimensions| Depth | 414 mm |
|---|---|
| Width | 366 mm |
| Height | 1087 mm |
| Weight | 33500 g |
To Next Page