Need help?Do you have a question about the Bowers & Wilkins MPA1 and is the answer not in the manual?
General| Output Power | 100 W |
|---|---|
| Input Impedance | 10 kΩ |
| Frequency Response | 20 Hz - 20 kHz |
| Type | Power Amplifier |
| Inputs | RCA, XLR |
Ensure the voltage selector panel is correctly set to the appropriate mains supply voltage before installation.
Connect the power cord to the mains supply, observing safety and wiring colour codes.
Connect the pre-amplifier output using either balanced or unbalanced audio inputs.
To Next Page
