Chest Strap Transmitter Battery Replacement
If your chest transmitter requires batteries, follow these instructions for replacement. The battery in your chest strap can
be replaced with a 3 Volt DC Lithium cell battery.
1. Remove the four screws from the battery door located on the rear of the transmitter.
2. Remove the battery door and the clear plastic battery cover.
3. Using a small, flat bladed screwdriver, gently pry the battery from the battery DS housing. Replace with a 3 Volt DC
Lithium cell battery.
4. When reinstalling the battery, be sure that the battery is placed into the housing with the positive “+” side up.
Replace the clear plastic battery cover ensuring that all three tabs are secured down beside the battery. Replace the
battery door and screws.
11
Using Your Heart Rate Monitor
To Next Page
Loading...
