Bowflex BXE116 - Page 67

67
Interior Pivot Cover
Lower Handlebar Arm
Upper Handlebar Arm
5.Usinga#2Phillipsscrewdriver,removethetwoscrewsthatsecurethe
Interior Pivot Cover to the Handlebar Arm.
6.Usinga6mmhexwrench,removetheindicatedhardwarefromthe
Lower Handlebar Arm and Pedal.
Be aware that the Handlebar Arm will be loose and will pivot
when the hardware is removed. Safely allow the Handlebar
Arm to pivot downward and come to rest. Be sure not to be in
the path of the Handlebar Arm.
Note: To assist with reassembly, observe how the Pivot Sleeve engages
ushwiththeLowerHandlebarArm.
7.Usingtwo6mmhexwrenches,removetheindicatedhardwarefromthe
Lower Handlebar Arm and the Arm Pivot Rod. The hardware on both ends
of the Arm Pivot Rod will need to be held to remove it.