Motor temperature has exceeded the
configured maximum. The controller will
shut down until the motor temperature
cools down.
The Red LED flashes once at power on as a confidence check and then normally stays Off. “1,
2” means the Red flashes once and after a second pause, flashes twice. The pause time
between multiple flash code groups is two seconds.
Using a damaged battery or charger can create additional bike damage or a fire hazard. Stop
using your battery and charger and contact Bowhead immediately if any of the following
occur:
(1) Your charger’s flexible power cord or output cable or any of the electrical cables on your
bike is frayed, has broken insulation, or any other signs of damage,
(2) Your battery or charger is physically damaged, non-functional, or performing abnormally,
(3) Your battery or charger experienced a significant impact from a fall or crash, with or
without obvious signs of damage, or
(4) Your charger becomes too hot to touch (it is designed to get warm with normal use),
makes a funny smell, or shows other signs of overheating.
Store any damaged battery or charger in a safe location and, as soon as possible, recycle or
otherwise dispose of it according to local rules. Contact Bowhead if you have any questions
or to purchase a compatible replacement battery or charger.
To Next Page
Loading...
