EN - User Manual
Safety Instructions
ThankyouforchoosingaMillarcoproduct!Weconsiderityourvoteof
condence.Forbestresults,pleasereadthefollowinginstructionscarefully.
Always keep these instructions with the power tool.
IMPORTANT!
Always carefully observe the following general safety rules when using power
tools.
To make sure that you work safely with this power tool, read the instruction
manual and safety instructions before operating the product. You should also
observethegeneralsafetyprecautions.Ifpossible,askaprofessionalto
demonstratehowtheproductworksbeforeyouuseitforthersttime.
• Always use safety goggles and
hearing protection
• Wearworkclothingandgloves
• Securetheitemtobedrilledto
prevent it rotating.
• Alwaysswitchthedrilloffwhen
changing the drill bit.
• Remembertoalwaysstandona
stable surface.
• Holdthedrillrmly.
Intheeventthatthebitbecomes
stuck,vibrationsmayoccurbriey.
• Coveryourhairifitislong.
• Neverusethedrillunderthe
inuenceofalcohol,medicineor
similar substances.
• Neverusethedrillwhenchildrenare
nearby.
• Protectthedrillfrommoisture,heat
andre.Donotstoreitonaradiator
or place it directly in sunshine, where
the temperature may exceed 40 °C.
• Donotusethedrillwithammable
liquids, chemicals or similar
substances.
• Alwaysstorethetoolsothatit
is out of the reach of children.
• Neveroverloadthedrill.
• Checkregularlythatallscrewsare
tightened.
• Neveruseyourhandstosecure
the item while you are drilling.
• Ensurethatyourngers,etc.donot
come close to the rotating parts.
• Checkthatthepowersourceis
“230 Volt” to the charger.
(Incorrectvoltagewilldamage
the drill and the guarantee will be
void) Use only the original charger.
• Replaceorrepairdefectivecables
immediately.
• Donotworkwithmaterials
containing asbestos.
• Whenworkingwithlight
building materials, you must comply
with statutory regulations and the
themanufacturer’sinstructions.
• Ifthedrillisdefective,alwayscontact
yourdealerorMillarco’sservice
department on tel. +45 8743-4233
or by email: service@millarco.dk