www.boxlight.com ©Boxlight 2022
3) Installing and Replacing Batteries
• On the back of remote control, open the cover of battery
compartment.
• Install AAA type battery according to the corresponding
electrode, make sure battery positive and negative pole are
correct ("+"to"+", "-" to "-"). Please do not mix using old and
new batteries.
• After battery is installed, close the back cover of battery
compartment. Make sure that the clip is buckled to the
bottom.
Note: To protect environment, please dispose waste battery
into recycling box.
If
the
battery
is
replaced
by
an
incorrect
type,
it
may
lead to explosion.
4) Range of Remote Control
Remote control can work normally within the range of 8 meters
distance and 30 degrees left and right from the remote control.
To Next Page
