The loading time of this new software is significantly shorter than the previous version.
Additionally, several new features were implemented to offer a better user experience.
In the Experiment page for AMPTS III (the same description is valid for AMPTS III Light – 9
lines), 18 lines are related to the 18 reactors where each one of them should be properly
labelled based on its content. In this page, using the function Print Experiment Guidelines, it
is possible to directly print or save the page in pdf format which contains information
regarding the parameters established for the test. The experiment setup can be arranged in
two ways: calculated or manual (Figure 15).
Figure 15. Experiment setup (A) Calculated and (B) Manual for AMPTS III.
If the calculated function is activated, the following parameters must be considered for each
line:
The manual function allows more set-up flexibility - information regarding the amount of
organic matter in the inoculum and substrate is directly entered.
To Next Page
Loading...