Model 4040DDS– Operating Manual
16
3.9 Power-On Settings
At power-on, the waveform generator performs a diagnostic self-test procedure to check itself for errors. If it find an
error, and error code and text appear in the display window. Other error codes appear when you enter and invalid
front-panel setting.
When the waveform generator finishes the diagnostic self-test routine it enters the power-on default settings.
Table 3-2 lists the factory default settings.
Table 3-2
Power-on Default Settings
Key Function Comments
FREQUENCY 1000 Hz Wave frequency
AMPLITUDE 5.00V Peak to peak output amplitude
FUNCTION SINE Output waveform
OFFSET 0.00V Zero offset
REPETITION 10ms Internal trigger rate
MODE CONT Waveform mode
TRIG SOURCE EXT External trigger source
SWEEP OFF Sweep execution
MODULATION OFF Modulation execution
To Previous Page
Loading...