B+S TF Series - Important Warnings

TF and RF Series B&S Commercial Kitchens
5
IMPORTANT WARNINGS
THIS APPLIANCE SHALL ONLY BE INSTALLED/SERVICED BY AN
AUTHORISED INSTALLER.
THIS APPLIANCE MUST BE INSTALLED IN ACCORDANCE WITH THE
SPECIFIED INSTRUCTIONS OUTLINED BY THE MANUFACTURER.
IMPROPER INSTALLATION OR OPERATION OF THIS APPLIANCE MAY
RESULT IN PRODUCT FAILURE WHICH MAY LEAD TO PROPERTY
DAMAGE, PERSONAL INJURY OR DEATH.
CAUTION MUST BE TAKEN WHEN OPERATING THIS APPLIANCE TO
MINIMISE RISK OF FIRE. THE APPLIANCE MUST NOT BE LEFT ON
UNATTENDED.
REGULAR INSPECTIONS BY AN AUTHORISED SERVICE PERSON ARE STRONGLY RECOMMENDED TO ENSURE
PROPER AND SAFE FUNCTIONING OF THIS APPLIANCE.
AFTER ANY SERVICING OR ADJUSTING OF GAS CONNECTED COMPONENTRY, GAS LEAK TEST MUST BE
CARRIED OUT TO ENSURE THERE ARE NO GAS LEAKING HAZARDS.
NEVER STORE ANY FLAMMABLE LIQUIDS/VAPOURS IN THE VACINITY OF THIS APPLIANCE. NEVER SPRAY
AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION.
ENSURE ANY TRANSIENT PROTECTION IS REMOVED BEFORE INSTALLING THE APPLIANCE ENSURING ANY
POSSIBLE DAMAGE TO THE APPLIANCE OR COMPONENTS/PARTS THAT MAY HAVE BEEN SUSTAINED
DURING TRANSPORTATION IS REPORTED TO THE MANUFACTURER.
THIS APPLIANCE IS NOT INTENDED TO BE USED IN A MARINE ENVIRONMENT.
ENSURE APPLIANCE IS INSTALLED IN A STABLE POSITION.
FAILURE TO FOLLOW THE INFORMATION PROVIDED IN THIS BOOKLET WILL VOID THE B&S WARRANTY
AND MAY RESULT IN DAMAGE TO EQUIPMENT OR INJURY TO PERSONNEL
TABLE 1: NOMINAL TERMINAL INPUT RATES & INJECTOR SIZES (PER PAN)
Burner Type
Gas Type
Injector Size (mm)
MJ/h
per
burner
Test Point
Pressure
TF-451
Natural Gas
Propane Gas
1.55mm (x9)
0.95mm (x9)
86.6
86.6
1.00 kPa
2.60 kPa
TF-451s
Natural Gas
Propane Gas
1.50mm (x8)
0.95mm (x8)
38
39
1.00 kPa
2.60 kPa
TF-601
Natural Gas
1.75mm (x9)
110
1.00 kPa
Propane Gas
1.10 mm (x9)
105
2.20 kPa
RF-1
Natural gas
Propane Gas
1.80mm(x11)
1.10mm(x11)
135
135
1.00Kpa
2.60KPa
RF-400
Natural Gas
Propane Gas
1.80mm (x9)
1.10mm (x9)
115
115
1.00Kpa
2.60KPa