To Next PageTo Next PageWhat to do if my Bradford White PDX250T6*FBN is showing seven flashes?
This indicates that gasoline vapors were detected at potentially explosive levels. Verify no gasoline vapors are still present. Reset the control by cycling power to the appliance or by cycling the ON/OFF switch. Replace the Flammable Vapors Sensor element if a gasoline spill event occurred.
How to turn on my Bradford White PDX250T6*FBN?
If the control LED is not on or flashing, and the power switch is in the “OFF” position or the supply voltage is interrupted, turn the power on.
Why does my Bradford White PDX250T6*FBN show three flashes?
The issue might stem from several causes: a vent blockage or improper vent configuration, kinked or blocked pressure switch tubing, a faulty pressure switch, the blower not spinning up to speed, the blower or exhaust temperature being too high, a faulty blower temperature switch, or the intake vent length exceeding the exhaust vent length. Check the vent or vent tables.
What does four flashes on my Bradford White PDX250T6*FBN mean?
This could be due to a thermal well sensor out of calibration, a faulty gas control, or a plumbing leak.
What does six-two flashes on my Bradford White PDX250T6*FBN mean?
This could be due to a vent blockage or improper vent configuration, kinked or blocked pressure switch tubing, a faulty pressure switch, the vent termination being affected by wind, the blower not spinning up to speed, the blower or exhaust temperature being too high, or a faulty blower temperature switch.
What does two flashes on my Bradford White Water Heater indicate?
This may be caused by pressure switch tubing that is kinked or blocked, a blocked pressure tap on the switch or blower, or a faulty pressure switch.
What does eight-three flashes on my Bradford White PDX250T6*FBN Water Heater mean?
This could be due to damage to the thermal well wire or the thermal well sensor resistance being out of range.
What does a short flash once per second mean on my Bradford White PDX250T6*FBN?
This could be due to an unstable pilot, a blocked or restricted pilot tube, oxidation build up on the pilot electrode, or wire damage to the pilot assembly or a bad connection at the gas valve.
What does six-one flashes on my Bradford White PDX250T6*FBN Water Heater mean?
This could indicate an unstable pilot, a pilot tube that is blocked or restricted, oxidation build up on the pilot electrode, or wire damage to the pilot assembly or a bad connection at the gas valve.
What does five flashes on my Bradford White PDX250T6*FBN mean?
This indicates that the pilot valve is stuck in the open position.
General| Brand | Bradford White |
|---|---|
| Model | PDX250T6*FBN |
| Category | Water Heater |
| Language | English |
Covers essential safety guidelines, hazards like fire, explosion, and personal injury, and general precautions.
Detailed instructions for responding to gas leaks and understanding flammable vapor detection.
Details error codes and troubleshooting steps for flammable vapor and temperature sensor malfunctions.
Covers troubleshooting for pressure switch failures, blower temperature switch issues, and flame sensing problems.
Provides a table linking LED status codes to probable causes and specific service procedures.
Guide for inspecting burner operation and adjusting the air shutter for optimal flame and combustion.
Comprehensive guide for testing, cleaning, and replacing the pilot assembly components.
Procedure for testing the function of the exhaust pressure switch and diagnosing potential blockages or failures.
Detailed instructions for the safe removal and installation of a new exhaust pressure switch.
Guide for testing the inlet pressure switch, including checks for blockages and continuity.
Step-by-step instructions for replacing the inlet pressure switch.
Procedures for testing blower operation, verifying voltage, and checking pressure.
