To Next PageTo Next Page
Need help?Do you have a question about the Bradford White RE2H50S 1NCTT Series and is the answer not in the manual?
General| Model Number | RE2H50S 1NCTT |
|---|---|
| Type | Electric |
| Capacity | 50 gallons |
| Voltage | 240 V |
| Wattage | 4500 W |
| Phase | 1 |
| Diameter | 22 inches |
| Recovery Rate | 21 GPH at 90°F rise |
| Inlet/Outlet Size | 3/4 inch NPT |
| Warranty | 6 years |
Covers safety, warnings, and important notes for appliance usage and installation.
Discusses how temperature setting affects hot water capacity and energy use.
Information on using mixing valves for point-of-use temperature reduction.
Details the control panel, display, and operation modes.
Describes different operating modes like Heat Pump (Only), Hybrid, Hybrid Plus, and Electric (Only).
Instructions for Vacation Mode and extended shutdown periods.
Discusses scald hazards, safety precautions, and factory settings.
Step-by-step guide on how to change the water temperature setpoint.
Explains how temperature setpoint affects hot water availability and energy consumption.
Installation requirements based on local codes and power supply specifications.
Guidance on selecting an optimal indoor location and specific considerations.
Specifies minimum clearances for performance and airflow.
Instructions for condensate drain, catch pan, and thermal expansion control.
Instructions for connecting hot and cold water lines, including union recommendations.
Requirements for controlling thermal expansion in closed systems.
Specifies requirements and installation of the T&P relief valve.
Explains the TCO and provides instructions for resetting it.
Details on branch circuit sizing, wiring, and grounding requirements.
A checklist covering tank location, plumbing, condensate, and electrical connections.
Explains what to expect during the initial startup of the unit in Hybrid Mode.
Step-by-step instructions for filling and draining the water heater tank.
Information on the Connect adapter, app, and optional grid connectivity.
Recommended annual maintenance tasks, including T&P valve, elements, and tank flushing.
Steps for draining, flushing, and cleaning the air filter.
Maintenance for condensate drain lines and anode rod inspection.
Answers common questions about filter, modes, and operation.
Lists fault codes, their counts, and corresponding conditions for troubleshooting.
