EasyManua.ls Logo

Bradford White RE2 - User Manual

Bradford White RE2
40 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Save this manual for future reference
Manual 238-51544-00B REV 08/18
SERVICE
MANUAL
Troubleshooting Guide
and Instructions for Service
(To be performed ONLY by
qualified service providers)
Models Covered
by This Manual:
Residential:
RE1 & RE3 Upright Models.
RE1 & RE2 Lowboy Models.
RE1 Utility Models.
RE1 Wall Hung Models.
Light Duty:
LE Upright Models.
LE Utility Models.
LE Lowboy.
LE Wall Hung.
Residential & Light Duty
Commercial Electric Water Heaters

Table of Contents

Questions and Answers

  • N
    njohnsonAug 11, 2025
    Why is there no hot water from my Bradford White RE2?
    • R
      Richard MorrisAug 12, 2025
      If your Bradford White Water Heater isn't producing any hot water, the issue might stem from several causes. First, check the fuses or circuit breakers in your service panel to ensure the heater is receiving power. Next, inspect all wire connections for any looseness. It's also possible that the upper heating element or thermostat is inoperative, requiring a check and potential replacement. Finally, examine the ECO and reset or replace the thermostats if necessary.
  • J
    Joann WardAug 17, 2025
    What to do if my Bradford White RE2 Water Heater doesn't have enough hot water?
    • M
      Margaret ColonAug 17, 2025
      If your Bradford White Water Heater isn't providing enough hot water, several factors could be the cause. Start by checking the lower heating element and replace it if needed. Ensure the thermostat is set to an appropriate temperature. Inspect all wire connections for looseness. Remove the heating element(s) to check for sediment or lime buildup. Reduce hot water demand during high usage periods. If the issue persists, consider that the heater might be undersized or that the inlet water is very cold. Also, check for reversed plumbing connections or a damaged dip tube, correcting or replacing them as necessary.
  • K
    kellijonesAug 25, 2025
    How to fix slow hot water recovery on my Bradford White RE2?
    • B
      Bradley PetersonAug 25, 2025
      If your Bradford White Water Heater has a slow hot water recovery, it could be due to a few reasons. Remove the heating element(s) and check for lime buildup. Check all wire connections for any looseness. Inspect the thermostat(s) and replace if needed. Also, verify the heating element's terminal block for the correct voltage and wattage rating.
  • A
    Alfred BrennanAug 30, 2025
    Why is my Bradford White Water Heater overheating?
    • S
      Shannon DiazAug 30, 2025
      If your Bradford White Water Heater is overheating or continuously operating, there might be a few reasons. Ensure the thermostat is flush with the tank surface. Check the heating elements for grounding and replace if needed. Adjust the thermostat to the desired setting. Also, inspect the ECO and replace the thermostat if necessary. If the water heater is too small for your needs, consider replacing it with a larger one.
  • A
    Ashley GallagherSep 4, 2025
    Why are my Bradford White RE2 Water Heater elements noisy?
    • S
      Scott EscobarSep 4, 2025
      If your Bradford White Water Heater's elements are making singing or hissing noises, it's likely due to lime formation on the elements. Remove and clean the heating elements, replacing them if necessary.

Bradford White RE2 Specifications

General IconGeneral
BrandBradford White
ModelRE2
CategoryWater Heater
LanguageEnglish

Related product manuals