To Next PageTo Next PageWhat does 7 flashes mean on Bradford White URG250T6N?
If your Bradford White Water Heater flashes seven times with a three-second pause, it indicates a gas valve electronic fault. First, verify that the control is not wet or physically damaged. Then, turn the set point knob to the 'OFF' position, then to the 'PILOT' position, and light the pilot. If the seven-flash error continues, the gas valve may need to be replaced.
What to do if my Bradford White URG250T6N Water Heater flashes 5 times?
If your Bradford White Water Heater displays five flashes with a three-second pause, it indicates a temperature sensor fault. This could be due to damage to the temperature wire or the temperature sensor resistance being out of range. Try turning the set point knob to the 'OFF' position, then to the 'PILOT' position, and light the pilot. If the issue persists, the temperature sensor may need replacement. If replacing the temperature sensor doesn't solve the problem, verify the control is not wet or physically damaged. If the five-flash error continues, consider replacing the gas valve.
Why does my Bradford White URG250T6N Water Heater flash 4 times?
If your Bradford White Water Heater shows four flashes with a three-second pause, it means there's an excessive tank temperature issue. This could be due to a temperature sensor being out of calibration or a faulty gas valve. The system requires a reset.
Why is my Bradford White URG250T6N flashing 3 times?
If your Bradford White Water Heater is flashing three times with a three-second pause, it suggests insufficient water heating. This could be due to a temperature sensor out of calibration or a possible short. Check the system settings and note that the system will reset.
What does 8 flashes mean on my Bradford White URG250T6N Water Heater?
If your Bradford White Water Heater is flashing eight times with a three-second pause, it indicates a false pilot flame. This can occur if the pilot valve is stuck in the open position. Try turning the set point knob to the 'OFF' position, then to the 'PILOT' position, and light the pilot. If the eight-flash error persists, consider replacing the gas valve.
What does 6 flashes mean on Bradford White URG250T6N Water Heater?
If your Bradford White Water Heater is flashing six times with a three-second pause, it means a water leak has been detected by the accessory module (on some models).
What does 2 flashes mean on Bradford White Water Heater?
If your Bradford White Water Heater flashes twice with a three-second pause, it indicates a weak pilot flame. This might be due to an unstable pilot or a blocked/restricted pilot tube. The system will automatically reset once a sufficient pilot flame is detected.
General| Brand | Bradford White |
|---|---|
| Model | URG250T6N |
| Category | Water Heater |
| Language | English |
Guidance on selecting an appropriate and safe location for the water heater installation.
Specifies required clearances around the water heater for safe operation and servicing.
Instructions for proper installation and maintenance of the water heater's venting system.
Details on providing adequate air for combustion and ventilation for safe operation.
Steps and precautions for connecting the water heater to the water supply system.
Procedures and safety guidelines for connecting the water heater to the gas supply.
Detailed steps for safely lighting and shutting down the water heater pilot and main burner.
Instructions on how to adjust the water heater's thermostat for desired temperature settings.
Procedure for visually checking the main and pilot burner flames for proper operation.
Annual and bi-annual maintenance tasks including thermostat, burner checks, and cleaning.
Ensuring proper air flow and maintaining a clear area around the water heater.
Maintenance for the temperature/pressure relief valve and sacrificial anode rod.
Monthly water draining and annual vent system inspection procedures.
