Bradley BS1019CE - Additional Error Codes and Status; Bisquette Burner Sensor Failure; Meat Probe Connection Issues

22 | Page
When the food has reached to the set point or timer has elapsed display shows the following:
BISQUETTE BURNER
TEMPERATURE SENSOR
FAILURE
When the smoker detects the sensor failure or loses
the connection,
the error code will be displayed with
an audible alarm. Press the rotary dial to cancel the
alarm. Check the sensor and its connections.
To replace the sensor see page 24
MEAT PROBE 1 /2 NOT
CONNECTED
When the smoker detects a probe failure or loses
the connection during the process, the error code
will be displayed with an audible alarm.
Press the rotary dial to cancel the alarm.
Check the sensor and its connections.
*Note: If sensor is not connected before starting the
smoking process, no alarms will be displayed.
MEAT PROBE 1 NOT
CONNECTED PROPERLY
When the system detects the partial resistance of
the probe, the message will be displayed.
Disconnect and reconnect the probe properly.
MEAT PROBE 2 NOT
CONNECTED PROPERLY
When the system detects the partial resistance of
the probe, the message will be displayed.
Disconnect and reconnect the probe properly.
ALL THE CONTROLS
HAVE BEEN DISABLED.
PLEASE CLOSE THE
DOOR BEFORE
CONTINUING THE
OPERATION
When the cabinet door becomes open, the message
will be displayed. Cabinet continues functioning as
programmed, but all the controls will be disabled.
After closing the door, all the functions will be
available again and the cabinet internal temperature
will be displayed.
Message on the display Smoker actions
Food temperature probe 1
indicator flashing Beeping sound only
Food temperature probe 2
indicator flashing Beeping sound only
Time indicator flashing
Beeping sound and all
heaters will turn off