How to increase water flow in Bradley Plumbing Product drench shower and eyewash?
Low water flow in your Bradley Plumbing Product drench shower and eyewash may be due to insufficient pressure or undersized supply piping. A minimum of 30 GPM is required. Increase the pressure or pipe size to resolve this.
Why is the scald-protection valve flowing water in my Bradley Plumbing Product?
If the scald-protection valve in your Bradley Plumbing Product is flowing water, it could be due to a few reasons: * The scald valve might be defective if the water temperature from the valve is below 80°F (27°C). Replace the scald valve. * Direct sunlight or high ambient temperature might be affecting the unit. Cool the unit. * The thermostat might be defective. Check continuity and replace it if the check fails; it activates at 50°F (10°C) (factory-set).
What to do if Bradley S19-304GA Plumbing Product freeze-protection valve is flowing water?
If your Bradley Plumbing Product's freeze-protection valve is flowing water, there could be several reasons: * If the water temperature from the valve is below 40°F (4°C), the power supply might be off. Turn the power on. * The water supply could be too cold. Make sure the unit is supplied with tempered water. * If the water temperature from the valve is below 40°F (4°C), the thermostat might be defective. Check continuity and replace it if the check fails; it activates at 50°F (10°C) (factory-set). * If the water temperature from the valve is above 40°F (4°C), the freeze valve might be defective. Replace the freeze valve. Note: A water supply of 40°F (4°C) or colder will hold the freeze bleed valve open. To close the valve temporarily turn the water off or plug the valve until t...
General requirements and qualifications for system installation and compliance.
Guidelines for regular checks and maintenance to ensure readiness.
Specifies the required tepid water temperature range for safe operation.
List of necessary materials and tools for installation.
Instructions for securely mounting the unit to the floor.
Guidance on assembling the showerhead and mounting safety signs.
Instructions for connecting optional signaling systems and extension cables.
Wiring schematic for the unit without any optional accessories.
Wiring schematic for the unit with optional signaling and indicator lights.
Addresses issues with insufficient water flow in the drench shower and eyewash.
Diagnoses and resolves problems with the freeze-protection valve.
Troubleshoots problems related to the scald-protection valve.
General| Category | Plumbing Product |
|---|---|
| Material | Stainless Steel |
| Spray Head Material | ABS Plastic |
| Flow Rate (Shower) | 20 GPM |
| Flow Rate (Eyewash) | 3 GPM |
| Compliance | ANSI Z358.1 |
| Number of Handles | 2 |
| Valve Included | Yes |
| Maximum Flow Rate | 20 GPM |
| WaterSense Certified | No |
| ADA Compliant | Yes |
| Mounting | Wall Mounted |
| Water Inlet | 1/2" NPT |
| Waste Outlet | 1 1/4 in NPT |
To Next Page