Bradman Lake HS - Setup Screen

HS Former
- 2 -
6.7 PLC Inputs Slot 1-2 22
6.8 PLC outputs Slot 3-4 22
6.9 Production Statistics 23
6.10 Current Alarm Screens 24
6.11 Alarm Statistics Screen 25
6.12 Machine Settings Screen 26
6.13 Changeover Screen 27
6.14 Setup Screen 1 28
6.15 Setup Screen 2 29
6.16 Main drive Speed 30
6.17 Clock Set Screen 31
7.0 OPERATING INSTRUCTIONS 32
7.1 Warning 32
7.2 Caution 32
7.3 Powering up the Machine 32
7.4 Pre-Start Checks 32
7.5 Starting the Machine 32
7.6 Jogging the Machine 33
7.7 Stopping the Machine 33
7.8 Turning Off the Main Supply 33
7.9 Safety Note 33
8.0 FAULT DIAGNOSIS/TROUBLESHOOTING 34
8.1 Troubleshooting 34
8.2 Vacuum System Diagnostic Chart 35
9.0 MACHINE ADJUSTMENT 36
9.1 Hopper Adjustment 36
9.2 Hopper Gate Frame Adjustment 37
9.3 Feed bar Adjustment 37
9.4 Plunger Adjustment 38
10.0 ROUTINE MAINTENANCE/CLEANING 39
10.1 Cleaning 39
10.2 Maintenance Schedule 39-40
10.3 Recommended Lubricants 41
11.0 INSTALLATION OF CHANGE PARTS 42
11.1 To Install A Forming Tool 42
11.2 To Install & Center The Plunger 42
11.3 To Set Corner Folders 43
11.4 To Set The Carton Blank To The Forming Tool & Plunger 43