Brady Bradyprinter 200MVP - Page 47

Bradyprinter 200MVP and 300MVP User’s Guide 37
yØÃAÏ
After you have installed the media and ribbon and the Power-On Self Test (POST) is
complete, the front panel display shows “PRINTER READY.” (If the printer fails its
POST, refer to page 73.) You may now set printer parameters for your application
using the front panel display and the four keys directly below it.
NOTE: Printers that are operating on an IP network can be quickly configured
via ZebraNet WebView
™
(optional ZebraNet
®
PrintServer II required). For
information, refer to ZebraNet Networking: PrintServer II Installation and
User’s Guide.
NOTE: Unless otherwise noted, all parameters are listed in the order they are
displayed, starting with “DARKNESS.”
(QWHULQJWKH6HWXS0RGH
To enter the programming mode, press the SETUP/EXIT key.
• Press the INCREMENT (+) or DECREMENT (–) key to scroll to the setting you
wish to change.
• Press the SELECT key to toggle the functionality of the INCREMENT (+) and
DECREMENT (–) keys.
• Press the INCREMENT (+) or DECREMENT (–) keys to increase or decrease the
value; answer “yes” or “no”; print a label; or select the digit you wish to change.
• Press the SELECT key again to use the INCREMENT (+) and DECREMENT (–)
keys to scroll to the desired menu item.
NOTE: An asterisk (*) in the upper left-hand corner of the display indicates
that the value displayed is different than the currently stored value.
All manuals and user guides at all-guides.com