What to do if my Braemar BSHV25D1S Air Conditioner has insufficient cooling?
If your Braemar Air Conditioner isn't cooling enough, it might be because the room was very hot when you first started the system; give the unit some time to cool the room. Also, check the air filter, as a dirty or blocked filter can restrict airflow. Clean the filter to resolve this.
How to fix Braemar Air Conditioner remote controller not working?
If the remote controller isn't operating your Braemar Air Conditioner, it might be out of range; the signal range is 8m. Poor signal reception could also be the issue; try removing any obstacles and electrical interference. If there's no display on the remote controller, check the batteries and replace them if needed.
Why my Braemar BSHV25D1S Air Conditioner does not run?
If your Braemar Air Conditioner isn't running, it could be due to a few reasons. First, there might be a power failure, in which case you should wait for the power to come back on. Second, check for a blown fuse or an open circuit breaker and replace the fuse or reset the breaker. Lastly, the thermostat setting might be too low in heating mode or too high in cooling mode. Make sure to check the thermostat setting, and if you are in ‘I FEEL’ mode, consider if the remote is in a cold (COOL mode) or hot (HEAT mode) location.
Why SET temperature can’t be adjusted on Braemar BSHV25D1S Air Conditioner?
If you can't adjust the SET temperature on your Braemar Air Conditioner, it might be because the unit is operating in AUTO mode, where temperature settings are not allowed. Alternatively, the temperature you're trying to set might be outside the allowable range of 16-30°C.
Why does my Braemar Air Conditioner make a clicking sound?
A clicking sound from your Braemar Air Conditioner during heating or cooling is normal. Plastic parts may expand or shrink due to a sudden temperature change, causing this sound.
Diagram illustrating the components of the indoor air conditioning unit.
Diagram illustrating the components of the outdoor air conditioning unit.
Crucial warnings regarding installation, operation, and regulatory compliance.
Table listing error codes and their corresponding descriptions.
Identification of critical issues requiring immediate attention and service.
Essential safety steps to follow before performing maintenance.
Solutions for power failures, circuit issues, and thermostat settings.
Troubleshooting remote control range, signal, and display problems.
Causes and remedies for reduced cooling performance.
General| Brand | Braemar |
|---|---|
| Model | BSHV25D1S |
| Category | Air Conditioner |
| Language | English |
To Next Page
