Brander TR6029 NG - Choosing a Location for the Heater

H. Installing Wheels
(1) SCREW____________8 Pieces
(2) NUT_______________2 Pieces
(3) WHEEL ____________2 Pieces
(4) BRACKET__________2 Pieces
(5) BOLT______________2 Pieces
(6) BASE ____________ 1 Pieces
(7) NUT_______________8 Pieces
Figure 9
I. Choosing A Location For The Heater
Caution
When objects are left under a heater in operation, they
will be subject to radiant
heat and this could result in damage.
This
heater is certified for outdoor use only.
J. CLEARANCES FROM COMBUSTIBLES
Respect clearances as shown:
-Sides of reflector: 24 inches (61CM)
-Above reflector: 18 inches (46 CM)
Figure 10
-Provide fresh air ventilation at all times.
-Respect minimum clearances to combustibles as shown in Figure 10.
-Install heater on level, solid, and stable ground.
-Do not install in an explosive environment. Keep away from areas where gas,
vapours, or flammable liquids are stored or used.
-In case of high winds, shut off the heater and gas supply. Remove reflector
and store the heater.
-Do not move the heater when hot.
9