25
Shaving (A)
Press the on/off switch (4) to operate the shaver.
The flexible shaving foils automatically adjust to every contour of your face.
Long hair trimmer (2)
To trim sideburns, moustache or beard, slide the long hair trimmer upwards.
Precision mode switch
(3)
For precise handling in hard to shave areas (e.g. under the nose) slide the switch (3) to
the right to position . One foil will be lowered.
Tips for a perfect dry shave
For best results, Braun recommends you follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
Cleaning (B)
Regular cleaning ensures better shaving performance.
Cleaning indicator
Your shaver should be cleaned daily in the Clean&Charge Station, and certainly when the
yellow cleaning light (7) shines constantly after shaving. If this is not done, the yellow
light will go off after some time. The shaver’s electronics will then assume it has been
cleaned manually and a new calculation of the time when the next cleaning is required
will be started. During the cleaning process in the Clean&Charge Station the yellow light
will flash and will go off after approx. 4 hours when cleaning is finished.
Automatic cleaning
Once the shaver is put into the Clean&Charge Station, it is cleaned automatically (see
«Clean&Charge Station (C)»).
Manual cleaning
Cleaning under running water:
• Switch the shaver on (cordless). Rinse the shaver head and the precision mode
switch under hot running water until all residues have been removed. You may use
liquid soap without abrasive substances. Rinse off all foam and let the shaver run for
a few more seconds.
• Next, switch off the shaver, remove the Foil & Cutter cassette (1) and let it dry.
• If you regularly clean the shaver under water, then once a week apply
a drop of light machine oil (not included) onto the long hair trimmer (2) and
Foil & Cutter cassette (1).
Cleaning with a brush:
• Switch off the shaver. Remove the Foil & Cutter cassette and tap it out on a flat surface.
• Using a brush, clean the inner area of the shaver head. However, do not clean the
Foil & Cutter cassette with a brush as this may damage it.
97191952_3090cc_CN-KR_S6-32.indd 2597191952_3090cc_CN-KR_S6-32.indd 25 07.04.15 10:3607.04.15 10:36
CSS APPROVED Effective Date 8Apr2015 GMT - Printed 11May2015 Page 25 of 32
To Next Page
Loading...
