EasyManua.ls Logo

Braun 3090cc - Operating Your Clean&Charge Station; Replacing the Cartridge; Accessories

Braun 3090cc
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27
Replacing the cartridge
After having pressed the lift button to open the housing, wait for a few seconds before
removing the used cartridge.
Before discarding the used cartridge, make sure to close the openings using the lid of
the new cartridge, since the used cartridge will contain contaminated cleaning solution.
The used cartridge can be disposed in the household waste.
Operating your Clean&Charge Station
Connect your Clean&Charge Station with the cord set to the mains electricity supply.
The special socket at the back is adjustable to save space. After each shave, switch
the shaver off and put it into the Clean&Charge Station, upside down and with the
front showing. Important: The shaver needs to be dry and free from any foam or
soap residue!
Push the start/release button (1) to lock and connect the shaver. The cleaning
process will start. The yellow light on the shaver will flash during the complete
process (approx. 2 minutes cleaning, min. 4 hours drying).
Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use.
If interruption is needed nonetheless, press the start/release button (1).
When cleaning is finished, the yellow light will go off. To release it, push the start/
release button.
A cleaning cartridge should be sufficient for about 30 cleaning cycles. When the
level indicator (4) has reached the « » mark, the remaining fluid in the cartridge is
sufficient for about 5 more cleaning cycles. Then the cartridge should be replaced,
when used daily approx. every 4 weeks.
The hygienic cleaning cartridge contains ethanol or isopropanol (specification see
cartridge), which once opened will naturally evaporate slowly. Each cartridge, if not
used daily, should be replaced after approximately 8 weeks to ensure optimal
desinfection.
The cleaning cartridge also contains lubricates, which may leave residual marks on
the shaver head after cleaning. However, these marks can be removed easily by
wiping gently with a cloth or soft tissue paper.
Clean the housing from time to time with a damp cloth, especially the opening where
the shaver rests.
Accessories
Available at your dealer or Braun Service Centres:
Foil & Cutter cassette: 32S/32B
Cleaning cartridge Clean&Charge Station: CCR
Environmental notice
Product contains batteries and/or recyclable electric waste.
For environment protection do not dispose of in household waste,
but for recycling take to electric waste collection points provided in your country.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
97191952_3090cc_CN-KR_S6-32.indd 2797191952_3090cc_CN-KR_S6-32.indd 27 07.04.15 10:3607.04.15 10:36
CSS APPROVED Effective Date 8Apr2015 GMT - Printed 11May2015 Page 27 of 32

Related product manuals