Description
1a Sliding beard comb (3–11 mm in 2 mm steps)
1b Sliding hair comb (13–21 mm in 2 mm steps)
1c Release button sliding combs
1d Fix comb 1 (1 mm)
1e Fix comb 2 (2 mm)
2a Trimmer head
2b Ear & nose trimmer head*
2c Detailed trimmer head*
2d Body groomer head*
2e Mini foil shaver head*
3 On/off button
4 Charging indicator
5 Power socket
6 Special cord set (design can differ)
7 Charging stand* * not with all models
For electric specifications, see printing on the special cord set.
Charging
Recommended ambient temperature for charging is 5 °C to 35 °C. The battery may not charge properly or at all
under extreme low or high temperatures. Recommended ambient temperature for trimming is 15 °C to 35 °C. Do not
expose the appliance to temperatures higher than 50 °C for extended periods of time.
Connect the appliance (switched off) via the special cord set (6) to an electrical outlet.
A full charge takes approx. 1 hour and provides up to 100 minutes of cordless operation time.
Once the appliance is completely charged, discharge it through normal use. Then recharge again to full
capacity.
Charging indicator (4)
The charging indicator blinks green when the appliance is being charged.
It lights up permanently green for a few seconds when the battery is fully charged. During usage it shines
permanently green.
The charging indicator shines permanently red when the battery is running low. Once it flashes red, connect the
appliance to the mains.
Usage
Exchange the attachments only when the appliance is switched off. To turn the appliance on, push the on/off button
(3).
Travel lock
Press the on/off button (3) for 3 seconds to lock the appliance. A beep confirms that the travel lock is activated. To
unlock, press the on/off button 3 seconds. 3 beeps will sound when your unlock attempt failed. Try again or simply
connect the appliance to the mains.
Beard Trimming / Hair Clipping
Sliding combs (1a, 1b): Place one of the combs over the trimmer head (2a). Press the release button (1c) and slide
the comb to your desired length. Fixed combs (1d, 1e): Click one of the combs onto the trimmer head (2a).
Trim against hair growth by guiding the flat comb part over the skin.
Do not force the appliance through the hair faster than it can be cut.
Avoid clogging the comb with hair. Remove and clean it from time to time.
Precision and Contour Trimming
Use the trimmer head (2a) without comb attachment, the detailed trimmer head (2c) or the mini foil shaver (2e) for
shaping sideburns, moustaches and partial short beards.
To Next Page
Loading...
