28
Cleaning
Automatic cleaning
After each shave, return the shaver to the Clean&Renew station and proceed as
described above in the section «Before shaving». All charging and cleaning needs
are then automatically taken care of. With daily use, a cleaning cartridge should be
suffi cient for about 30 cleaning cycles.
The hygienic cleaning cartridge contains ethanol or isopropanol (specifi cation
see cartridge), which once opened will naturally evaporate slowly. Therefore each
cartridge, if not used daily, should be replaced after approximately 8 weeks.
The cleaning cartridge also contains lubricants, which may leave residual marks on
the outer foil frame after cleaning. However, these marks can be removed easily by
wiping gently with a cloth or soft tissue paper.
Manual cleaning
Rinsing the shaver head under running water is an alternative way to keep the shaver
clean, especially when travelling:
• Switch the shaver on (cordless) and rinse the shaver head under hot running
water until all residues have been removed.You may use liquid soap without
abrasive substances. Rinse off all foam and let the shaver run for a few more
seconds.
• Next, switch off the shaver, press the release button (9) to remove the Foil & Cutter
cassette (8) and let it dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light
machine oil (not included) on top of the Foil & Cutter cassette and the long hair
trimmer.
Alternatively, you may clean the shaver with a brush:
• Switch off the shaver. Remove the Foil & Cutter cassette (8) and tap it out on a fl at
surface. Using a brush, clean the inner area of the pivoting head. However, do not
clean the cassette with the brush as this may damage it.
Cleaning the housing
From time to time clean the housing of the shaver and the Clean&Renew station
with a damp cloth, especially inside the cleaning chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button (2) to open the housing, wait for a few seconds
before removing the used cartridge to avoid any dripping.
Before discarding the used cartridge, make sure to close the openings using the lid
of the new cartridge, since the used cartridge will contain contaminated cleaning
solution.
91508132_7760cc_JP.indd 2891508132_7760cc_JP.indd 28 24.07.17 15:2824.07.17 15:28
CSS APPROVED Effective Date 27Jul2017 GMT - Printed 04Sep2017 Page 28 of 34
To Next Page
Loading...
